Error When trying to...

Stillsy · 7th November 2002, 3:55 PM

Hi Pete,

When I try to send a PM I get the following error, is this just a one off?

==============================================
Ikonboard CGI Error
--------------------------------------------------------------------------------
Ikonboard has exited with the following error:

Not Enough Parameters!

This error was reported at: Sources/Lib/FUNC.pm line 1504.

Please note that your 'real' paths have been removed to protect your information.

==============================================
Cheers Stillsy

Pyro Pete · 7th November 2002, 5:54 PM

Just sent you a PM it seemed to work for me.

There are numerous PM bugs, use direct e-mail where possible.

If anyone else also gets the above problem let me know.

Stillsy · 7th November 2002, 8:39 PM

Hi Pete,

Yes, got your PM no problem but cannot seem to send the one I want to to Adam. Keep getting the same error message.

Adam - can you PM me (or mail me) an e-mail address to send to you, not sure if the one I already have is still valid ??

Cheers
Stillsy